Iron heads bent to flat with over length shafts

Follow Thread

By MnmEvans

  • 0 Likes
  • 3 Replies
  1. MnmEvans

    MnmEvans
    Dallas, TX

    Military

    My inquiry is in regards bending iron heads flat that are defaulted to 2 degrees upright when ordering shafts at 3/4 over length or longer. Why can’t the heads be bent flat at all when this is the case?

  2. Chuck Z

    Chuck Z
    Mt Pleasant, SC

    Military
    Not a fitter and cannot answer this. Wish I could help you out.
  3. Frank P

    Frank P
    Port St. Lucie, FL

    Military
    If you are talking about bending an existing set that is already at 2 deg. upright, most mfgs. suggest not bending for lie not more than 2 degrees up or down. Bending from 2 deg. upright to 1 deg. flat would be a 3 deg. bend. If you are ordering new, you should be able to get whatever lie is needed regardless of shaft length.
  4. Abdon M

    Abdon M
    Northern California (because it's a big state)

    I believe with custom orders, you should be able to get the requested lie adjustment without messing with the shaft length. As for adjusting the club's lie angle post manufacturing, much easier to do with forged clubs than cast clubs.

Please login to post a comment.

Sign In

Haven't registered for Team Titleist yet?

Sign Up

Find a golf store near me