716 AP2 fitting with Project X

Follow Thread

By TITLEISTUSER

  • 0 Likes
  • 2 Replies
  1. TITLEISTUSER

    TITLEISTUSER

    I was recently fitted for AP2 at a local Roger Dunn fitting center (Jim was my fitter, great guy). We were going through various shafts and I ended up liking the Project X 6.0 but I noticed that there was a new shaft that came out relatively recently called Project X LZ. The fitting center did not have that shaft available for me to test but after reading the literature, its seems like it could be compatible for me as well. Will I notice a big difference?

  2. MMHarmon32

    MMHarmon32
    St Louis, MO

    Military
    The LZ shafts are great, but probably not worth the extra premium over the 6.0s. They have a better 'energy transfer' in the mid section, but even they say it is, at best, a 7% increase. They do -feel- great, though. Definitely give them a try, and then weigh the cost vs benefit.

    Can't go wrong with the standard Project X.
  3. Chuck Zirkle

    Chuck Zirkle
    Mt Pleasant, SC via Rocky Top Tennessee

    Military
    Same weight. The Project X LZ 6.0 with be a mid launch where the Project X 6.0 is a low launch. The stock shafts a bit longer, but if you were fit, I would check with the fitter before ordering these and get their professional advice.

Please login to post a comment.

Sign In

Haven't registered for Team Titleist yet?

Sign Up

Find a golf store near me Find a Fitting Event